Common faults and solutions for inflatable castles

1: Scratch

If the scratch is longer than 5 cm, it should be stitched with needle and thread first, and then glued to the seam with cloth strips. If the scratch is less than 5cm, just use a cloth strip to paste it to the scratch.

2: Leakage

After the product has been used for a long time, the air leakage will increase due to the enlarged pinholes and seams in some parts. At this time, you can consider pasting cloth strips on the seams to reduce the amount of air leakage. If it is too old, it should not be used again to prevent safety problems in the operation.

3: Degumming

The easy-to-wear parts of the inflatable castle are easy to degumming after long-term use, so you can use the cloth to cut into different shapes and stick it on the degumming place.

4: Edge warping

Use a small brush to apply an appropriate amount of glue on the warped edge, then press and stick it tightly.

Maintenance

1: Before the inflatable castle is deflated, wipe its surface with a wet towel, deflate it after drying, fold it and store it in a cool and clean place;

2: If it has water ingress due to poor storage, you need to put it in a dry and ventilated place and blow it up when it cannot be drained, and let it dry until the water evaporates. Do not store it with water;

3: The blower should be stored in a dry and ventilated place to prevent moisture;

4: If the inflatable castle is stored for a long time, it should be checked regularly for moisture.

Please maintain your inflatable castle in strict accordance with the above requirements. Dinis Amusement is willing to provide you with assistance. If you have other needs, please contact us in time.